I purchased a bushnell scope 2.5x10x44 30 mm . I have a valcun 2 25.cal bullpup wanting input on which scope rings would be a good fit. Thanks Okie
scope rings
- Thread starter Okie1959
- Start date
I'd get anything that has elevation adjustment, like the FX No-Limits, the Burris XTR Signature rings, or something similar. This allows you to tune the scope height with the rifle at a given zero range, while keeping the optics fairly centered. Or if you shoot a lot of long range and will be dialing the turrets a lot, it also helps you get all the elevation adjustment out of the scope (by starting the turret out near the top of its range).
Upvote 0
The FX rings as suggested are good. I find the Sports Match fully adjustable to be the best. For springers they include a recoil pin (not needed in your case) but they are more finitely adjustable than the FX.
Upvote 0
I own both fx no limits and sports match fully adjustable the sports match fully adjustable rings are better in that they can be adjusted for (windage) along with elevation.
Upvote 0
The Burris XTR Signature rings allow you to make definite adjustments, e.g., 5 mil up* — whereas the other models are a trial and error method of adjusting-and-checking-if-it's-enough.... 
*[Burris publishes a detailed table of the adjustment values in different configurations]
Also, if you are concerned to keep you scope as low as possible to have your point blank range closer to you — the low XTR Signature rings seem to be lower than the other models.
Lastly, the XTR Signature rings seem to allow for larger elevation adjustments* than the other models mentioned so far.
*[if they are mounted just right]
Happy shopping,
JungleShooter
*[Burris publishes a detailed table of the adjustment values in different configurations]
Also, if you are concerned to keep you scope as low as possible to have your point blank range closer to you — the low XTR Signature rings seem to be lower than the other models.
Lastly, the XTR Signature rings seem to allow for larger elevation adjustments* than the other models mentioned so far.
*[if they are mounted just right]
Happy shopping,
JungleShooter
Upvote 0
I have a valcun 2 25 cal, bushnell 2.5x10x44 and eagle vision adjustable rings. My question is do I need to raise the rear ring when setting scope up for 100 yards more or less? Thanks Okie
Upvote 0
Up on rear and down on front raises POI.
The Burris XTR Signature rings allow you to make definite adjustments, e.g., 5 mil up* — whereas the other models are a trial and error method of adjusting-and-checking-if-it's-enough....
*[Burris publishes a detailed table of the adjustment values in different configurations]
Also, if you are concerned to keep you scope as low as possible to have your point blank range closer to you — the low XTR Signature rings seem to be lower than the other models.
Lastly, the XTR Signature rings seem to allow for larger elevation adjustments* than the other models mentioned so far.
*[if they are mounted just right]
Happy shopping,
JungleShooter
I have multiple sets of each and like each for specific uses. The Burris rings move in steps related to insert size. The SportsMatch rings adjust fluidly in small amounts. I have Burris on many firearms but only use SportsMatch on airguns. Either will work.
Upvote 0