Yes, on my first phase of modding I went 5mm all the way from top to the valve pin and stayed with the 6m barrel set screw. Mine doesn't have the power wheel but I would think it would also need opened the same. It was just on phase 2 that I opened it up to 6.5mm, same as a Boss (kinda of stressful though as that's a big ass hole to be drilling through your receiver, lol). When I say transfer port/ports I'm referring to all the air passages. Plenum port might be a better term for the lower passage. In the above attached link Weatherby gives all the dimensions between basically three guns. Good luck and holler if I can be of anymore help.
Be warned, once you get started it's hard to stop with the mods. You might also be interested in adding a second gauge for your regulated pressure. It's sure nice knowing at a glance what it is.
Be warned, once you get started it's hard to stop with the mods. You might also be interested in adding a second gauge for your regulated pressure. It's sure nice knowing at a glance what it is.
Upvote 0