Ring height for Avenge-X with high cap mag

[floridaman]

I am deciding which ring height to get to mount my Bugbuster scope to my new Avenge-X. I read that if you have anything but the high mount, you can't use the higher capacity mag. My only concern with the higher mount is that most of my shots will be at close range, within 10-40 yards. If I go with the med/low profile mount am I forced to only use the low cap mag? These are the 3 I am looking at. I will be using the gun for iguana hunting.

 

[bucketboy]

I wouldn’t be concerned about having a smaller capacity magazine, for close range lower mounts are better providing you can get the correct head position.

Bb

 

[floridaman]

I wouldn’t be concerned about having a smaller capacity magazine, for close range lower mounts are better providing you can get the correct head position.

Bb

Alright, I can just buy a few of the small cap mags, I am using the gun for iguana hunting so I didn't want to be fumbling around too much with the mags since the .25 only holds 8 rounds, but that is fine. Short range accuracy is priority for me.

 

[bucketboy]

on the bright side, smaller mags take less time to fill, are cheaper to buy and don’t weigh as much

 

[mitchum]

Use the bigger mag. Why limit yourself. I have the avenge x tactical 25 cal. high profile rings head position is fine.
buy a cheap set of rings on Amazon. They include both heights.

 

[floridaman]

Darn, I got the medium height and its literally like a sheet of paper away from fitting. I'll have to either use the low cap mags or switch to the high mount.