Brocock/BRK Replace Ghost Gauges?

Jump to latest Follow Reply
J

Jay308

Member
Sep 30, 2023
516
489
Raleigh, NC, USA
So my reg gauge is moving in steps, I was going to replace those tiny ones anyway.

I want to use sekhmet 25mm but they say not to use a dowty seal on them(dangerous). Can you use a x-ring in the gauge hole? The regulator gauge hole has the opening in the side, not sure that will work? I have a bag of x-rings from my FX.

What size dowty seals are on the stock gauges? Any links if you have ordered them? Seems Wika gauges can use a dowty seal, I may go that route also.

Any help is appreciated.
 
Jay308 said:
So my reg gauge is moving in steps, I was going to replace those tiny ones anyway.

I want to use sekhmet 25mm but they say not to use a dowty seal on them(dangerous). Can you use a x-ring in the gauge hole? The regulator gauge hole has the opening in the side, not sure that will work? I have a bag of x-rings from my FX.

What size dowty seals are on the stock gauges? Any links if you have ordered them? Seems Wika gauges can use a dowty seal, I may go that route also.

Any help is appreciated.
Click to expand...
Hello

are you trying to fit 25mm on Ghost? I wouldn’t try fit 25mm on Ghost.

28mm size is for Ghost.
I used PTFE(white plastic) in the gauge hole on my Ghost because I didn’t see any oring inside, then I added oring.
 
Upvote 0
Jay308 said:
So the regulator side read fine even though the sensing hole is on the side and not the bottom. If so, I’ll try it.
Click to expand...
if white plastic is blocking hole, don’t use it. All you need is one oring.
ex) on my Mora, when I took out factory gauge oring was still inside so I just install Sekhmet. no extra oring needed.(25mm Sekhmet for Mora)
 
Upvote 0
I cannot see any reason the 25 mm wouldn’t be just fine. It is an easy to use straight forward gauge. I think the 28 mm one has all the features and is more expensive. If it were me I’d go 25…bigger than stock but smaller than the large 28.

I’m following as I have an extra 25mm one I was thinking of putting on my delta wolf. Does sekhmet state why the dowty cannot be used ?
 
Upvote 0
Trucker3573 said:
I cannot see any reason the 25 mm wouldn’t be just fine. It is an easy to use straight forward gauge. I think the 28 mm one has all the features and is more expensive. If it were me I’d go 25…bigger than stock but smaller than the large 28.

I’m following as I have an extra 25mm one I was thinking of putting on my delta wolf. Does sekhmet state why the dowty cannot be used ?
Click to expand...
I kinda think as long as you don’t torque it hard it might be ok?

There is the Outgun angle bracket that you can use the dowty on the base piece and the gauge screws into the bracket with a xring. https://www.sekhmetonline.com/produ...uge-bracket-for-fx-brk-skout-airforce-airguns

IMG_6523.jpeg
 
Last edited:
  • Like
Reactions: Trucker3573
Upvote 0
Last edited:
  • Like
Reactions: Trucker3573
Upvote 0
You must log in or register to reply here.
Top Bottom
Back
Home
Forums
Resources
Menu