Red Wolf O-Rings?

[elh0102]

This is what I ordered for my Red Wolf .22 standard. 

Would you happen to have that info for the .25 and .177? That would be golden!

scratchcoobster - I’d use the info elh0102 posted and get the packages from Oringstore.com.

The parts list I used in ordering is the one listed above by "trlrman". It predates some of the HP stuff, but should otherwise be accurate for .25 and .177. 

 

[trlrman]

The #'s are correct for 25 hp and safari 30 the only 2 I own at this time .

 

[ronmcc4]

Asking Steve sounds like a good idea.

 

[nomojo65]

arzrover can give you all the o-ring sizes for every o-ring in the RedWolf and they will be correct! He is the RW guru! 

 

[tscktran]

 

Red Wolf 177, breech orings (4mm x 1.5mm) and the breech end of the barrel orings (12mm x 1mm for HP, 10mm x 1 mm for standard)

The info I got from Arzrover

 

[nomojo65]

I bought VITON For my .177hp not sure of the rating for sure, believe it’s 75d? but they hold up much better than the original in my .22hp

 

[Arzrover]

Thanks for the vote of confidence , guys. I have done a lot of testing and analysis on them but the guys at AoA handle a couple of hundred of them to my 1. There are others that may know a lot more as well, just not vocal.

Only trying to be helpful.

I think this question has been answered a few times on here, though.

I'll post a pic in a few minutes that shows all the oring sizes in the Daystate kit.

Bob

 

[Arzrover]

Her is the kit label. Note that it's for all 4 calibers.

The 006 should be polyurethane in 90 D and I use Viton the others for it's superior strength, temp, and chemical resistance. Buna has a better LOW TEMP performance if you shoot much in really cold temps.

Hope this helps, 

Bob