For months I've been using the single shot tray, Well this morning I decided to use the magazines and immediately had trouble seating the magazines into position. Eventually I discovered that the magazine would not cycle. Long story short I've decided to just use the single shot tray.
I'm considering just using some hard epoxy and cementing the hole that the activator pin comes thru, removing the activator pin, spring and just screwing the two 3m screws holding the assemble back in place.
My question is as follows. Is there anything else that needs to be done other then sealing that small hole that the mag activator pin goes thru?
I'm considering just using some hard epoxy and cementing the hole that the activator pin comes thru, removing the activator pin, spring and just screwing the two 3m screws holding the assemble back in place.
My question is as follows. Is there anything else that needs to be done other then sealing that small hole that the mag activator pin goes thru?