Hi friends,
I am working on making a plenum for RAW HM1000X post takeover model that could be attached between the block and the regulator.
The RAW guns that I own are pre takeover models.
Later RAW has increased the dia of the regulator to enlarge the plenum a bit as shown in following picture.
For the above ( post takeover) regulator model I need following specs.
The length and dia of the regulator cavity highlighted in red colour in following picture which is smooth without threads.
2nd is the size of O ring on the regulator as shown in the following pic with red colour .
This will be a great favour to me.
Regards,
Bhaur
I am working on making a plenum for RAW HM1000X post takeover model that could be attached between the block and the regulator.
The RAW guns that I own are pre takeover models.
Later RAW has increased the dia of the regulator to enlarge the plenum a bit as shown in following picture.
For the above ( post takeover) regulator model I need following specs.
The length and dia of the regulator cavity highlighted in red colour in following picture which is smooth without threads.
2nd is the size of O ring on the regulator as shown in the following pic with red colour .
This will be a great favour to me.
Regards,
Bhaur