corny, thank you for the info on his magazines....very nice! I have an older HMx model with the smaller breech, I wonder if he could adjust and print smaller right load versions? I guess I'll contact him and see.....
no problem…glad to refer good products. These are not printed. They are fully cnc machined. Very much like the raw mags in build and feel.
some key design differences. U have to load one pallet reverse from the back. The locking mechanism works differently, u lift at the tab….lid flexes and pops/locks onto the machined pin.
I’m not sure if he intends to offer right and left loading. But I have seen both in the prototype stages.
My guess is yes, he should be able to adjust for the thinner mag.
I think it’s .072 thinner
I actually glued some strips of plexi glass on a thin one to make it thick.