I have been looking for a replacement seal that goes in between the CO2 cartridge and the puncture needle on a umarex Glock 17 non blowback air pistol . Does anyone have a line on where to get one or a substitute . Tried umarex but they are tight with parts
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Tuning Puncture needle seal for
- Thread starter Sealme
- Start date
You could try making one out of a thin sheet of rubber, use a hole punch or similar to take out a small circle, and stick it in. It may not work but is worth a shot.
Upvote 0
Otherwise, try putting some thin oil on the original seal, I have had many gaskets and the like leak on my PCP's and a little bit of thin oil can usually prolong their life a bit more.
Upvote 0
I tried the Teflon tape .pellgun oil and silicon grease (petroleum free ) and it still leaks . Maybe I need some new CO2 and hopper area seals . Is there anywhere that has them ? Thanks for the reply btw
Upvote 0