Presslug support and discussions

[markus417]

not sure if this will help? there is a set screw on the back of the presslug loosen that then move the top.

you'll need a small punch and hammer to tap it loose... don't try the spanner wrench ...the wrench will break...been there done that!!

 

[blitzen]

Have you seen any difference in POI with a tenth grain difference in weight? My scale measures out to the hundredth and I believe my slugs are all inside of a tenth difference in weight. Also I will rotate the slug and the die will shave a little off. Which tells me that the die is not symmetrical-I rotate it .25 4 times and it shave weight almost every time.

 

[markus417]

Have you seen any difference in POI with a tenth grain difference in weight? My scale measures out to the hundredth and I believe my slugs are all inside of a tenth difference in weight. Also I will rotate the slug and the die will shave a little off. Which tells me that the die is not symmetrical-I rotate it .25 4 times and it shave weight almost every time.

I don't think it makes any difference in that small of a weight.. I have had store bought that vary 3 tenths of a grain and all was good... I think you may be right about the dies!! something is off, not sure what but they don't fly with accuracy

 

[UDABEGGER]

I will my setup was ordered last december when i inquired with corbin about 6 weeks ago they responded with.... most my order was complete just waiting on a couple punches they told me then it would all ship within a week or 2 lol that was 6 weeks ago. I knew that wait times were extreme ....at time of order i was told 60 to 120 days. But i knew i would have to wait a long time

Got my Corbin end of July . I could not be more impressed and happy . Great accuracy -consistancy and teck support . Easy !