I don’t think mine likes the JSB mk2 33.95 @910 fps. I’m almost through 2 tins and having issues. I want to stay with heavier pellets.
Pellet suggestions for a .25 Ghost HP?
- Thread starter Jay308
- Start date
I got the AEA 33.9’s, cleaned the barrel and it took 10 shots to lead in. It put them into tight 5 shot groups and I was shooting the grid on the target making nice straight lines. If it shoots the same next session, onto the 30 yard challenge finally.
Thanks again
Thanks again
Upvote 0
I have an Alpha wolf which I imagine has the same barrel. Could try slowing them a bit. My barrel seriously likes everything (at least out to 50) in the 880’s fps range.
Upvote 0
I can try that too, thanks for the input.
Nice having a balance valve, just turn the power wheel down 2 settings.
Last edited:
Upvote 0
Accuracy stayed good on todays session. I also got the chrono out and dropped the PW from 10 to 8 and it averaged 884fps with a 2.5 SD / 7 ES. I hope this continues!
The groups stayed the same at 25 yards at 910 to 880 fps but the SD/ES improved.
The groups stayed the same at 25 yards at 910 to 880 fps but the SD/ES improved.
Last edited:
Upvote 0
I'm going to second, third and fourth on the AEA's. These are out of my JSAR Raptor .25, bottom left are the 30.2 slugs, 969.6fps top right are the 33.9, 932.6 fps pellets, I was shooting for SD not accuracy at 25 yards. 8 seconds/shot. SD of 1.29 on the slugs and .9 on the pellets, threw out the first one, it's always a tiny bit faster after reloading. Zero didn't change appreciable.
Upvote 0
They'll work, it's a very fine line between the AEA's and JSB's as to which works the best, I just feel that the AEA's a a minute bit better. I'm running 1375 psi on the second reg, and tuned the daylights, out of it. I could go heavier but I feel I'm working the gun too hard and I don't have a need.
Upvote 0