PCP Baffle Help

[ClarkT]

I see that someone provided a link to when I was battling with my first Priest and was experimenting with Mrod baffles. Here’s a link to what’s in my current Priest. It’s very quiet. The gun has evolved since then but what I use to silence it still remains the same.https://www.airgunnation.com/topic/priest-slug-project/?view=all

Thanks Vet for sharing. That’s similar to my current set up but I don’t have an air stripper. So I look forward to trying that out.

 

[ClarkT]

and my testing begin...

here you see a cone that was based on the STL provided @BigTinBoat, thanks buddy! The design is mine, I just got the idea from the files you sent me. I added a few holes to the cone, my idea is restrict the amount of air that goes to the next "chamber" but start reducing that amount little by little... I don't know if that will work or not but I think it will help... I'll test with and without the holes...

The other two things you see there are two separators, I'm testing with one with a flat base that could be use as the first baffle too, I'm testing... I'll keep this post updated with my progress.

Ohh, I've received the super strong material and these are going to be printed with it... I remember I was playing once with PLA and after 3 shots the cones were ground meet inside my shroud LOL... I hope this will be strong enough now that I have that strong plastic.

Looks good! Interested in your results

 

[BigTinBoat]

and my testing begin...

here you see a cone that was based on the STL provided @BigTinBoat, thanks buddy! The design is mine, I just got the idea from the files you sent me. I added a few holes to the cone, my idea is restrict the amount of air that goes to the next "chamber" but start reducing that amount little by little... I don't know if that will work or not but I think it will help... I'll test with and without the holes...

The other two things you see there are two separators, I'm testing with one with a flat base that could be use as the first baffle too, I'm testing... I'll keep this post updated with my progress.

Ohh, I've received the super strong material and these are going to be printed with it... I remember I was playing once with PLA and after 3 shots the cones were ground meet inside my shroud LOL... I hope this will be strong enough now that I have that strong plastic.

Glad to help out.

I just took mine apart to clean the barrel. Here is exactly what I have inside my shroud. I used 1 piece of PVC, 2 of those baffles and a "flat" baffle last, then the end cap.

I printed these at the library and pretty sure they are just PLA. This is how they are holding up between 30-40fpe.