Anyone know where I can buy a after market pop-it valve for the Nova Liberty 22 cal. Been told that it is the same as for the Air Venture Avenger.
Tuning Nova Liberty pop-it valve
- Thread starter press
- Start date
Been told that that is a weak point with the liberty. Mine started leaking after about 500 shots. takes about three days to leak from 3500psi to 0. I put a balloon over the end of barrel to confirm what was leaking.
Upvote 0
Duy (darkcharisma) was making parts for them but from what I'm seeing on his site, he may have pulled back to catch up on orders.
https://dctunes.square.site/s/shop
Otherwise most anyone with a lathe could make one. Doing one of anything is usually pricey though because of the setup time.
https://dctunes.square.site/s/shop
Otherwise most anyone with a lathe could make one. Doing one of anything is usually pricey though because of the setup time.
Upvote 0
Thanks for the link https://dctunes.square.site/s/shop .
I didn't know he had a website set up for his work. Maybe I will look into converting the 3 Nova Vista Freedoms to bottles? They were VERY accurate (except the .22 which I never could get working properly, so I don't know about that one) and I really liked the ability to switch from ~12fpe to ~20fpe with the simple twist/turn of a knob!
Upvote 0
A few months ago, upon reading a post in the forums stating that the Avenger valve fit the Nova Vista guns I ordered a pair from Pyramyd/Air Venturi.
The valves do no appear on the website.
I emailed Customer Service about availability,and in follow up emails they put an order together for me.
Hope this helps
Ed
PS
It is rumored that the Avenger poppets are made of a different (better) material than the Nova Vista, but I cannot verify that
The valves do no appear on the website.
I emailed Customer Service about availability,and in follow up emails they put an order together for me.
Hope this helps
Ed
PS
It is rumored that the Avenger poppets are made of a different (better) material than the Nova Vista, but I cannot verify that
Upvote 0
I need this part a as well dam my gun started leaking after 5 yrs of having it ugh plz someone let me know where I can find one
Upvote 0
If you send the dimensions of your poppet to Maple Custom, & they have the shaft OD in stock they can custom make you one real quick in either Delrin or Peek. I also put an Aspen poppet, made from the new material they switched to in 2021 in my Liberty back 2 yrs ago & it's held air since. I got it from PA. The part no. is PY-A-9593.
Upvote 0
Thank's Chris- Are you sure the poppet is the problem? Put air in your rifle & take your shroud off & tape a balloon to the end of the barrel & if it fills the balloon it is your poppet or valve o'rings. Other o'rings can leak & cause similar leaks.
Upvote 0