Ninja reg for pcp’s, 3k output has a ball and spring as a valve. Cant see the ball in thr pic but its in there. Adapter block has a detent to open the valve, but made for a pin valve which sits flush and not recessed. When this one screws in, nothing pushes the ball in. Air up and it holds, just nothing past the block.
Not being really familiar with these type of regulators, can the ball and spring be swapped for a pin type? Would an regulator extension work? Bonnet swap? Besides keeping air in the reg and bottle when removed, is there any reason to keep the valve installed? Apologies if im asking stupid or basic questions. Id rather err with caution and safety than FAAFO the hard way. Thanks in advance for responses.
Not being really familiar with these type of regulators, can the ball and spring be swapped for a pin type? Would an regulator extension work? Bonnet swap? Besides keeping air in the reg and bottle when removed, is there any reason to keep the valve installed? Apologies if im asking stupid or basic questions. Id rather err with caution and safety than FAAFO the hard way. Thanks in advance for responses.
