New Edgun Leshiy 2 Badger Won’t Bleed

[eglassy]

Hey Guys!

I received a new 30 cal Edgun Leshiy 2 a few days ago and when I turn the bleed screw it doesn’t release any air. I’m sitting at 100 bar on the gauge. I tested shooting to make sure it wasn’t the gauge and it’s still firing so not the gauge. Any ideas?

 

[madeintheuk]

Are you loosening the correct screw? Do you have a picture of which one you’re unscrewing?

 

[woogie_man]

Do you have a bottle on it?

If not you can remove that little plastic angle piece on the end of the cylinder. There is a set screw under there you can use to degas the system

 

[Aikidolou]

Hey Guys!

I received a new 30 cal Edgun Leshiy 2 a few days ago and when I turn the bleed screw it doesn’t release any air. I’m sitting at 100 bar on the gauge. I tested shooting to make sure it wasn’t the gauge and it’s still firing so not the gauge. Any ideas?

Try shooting it down then once close to zero remove gauge and open and close the bleed screw. Close then fill and see if it bleeds?