I just installed a extra high pressure huma reg to my gen2 impact and the highest reg pressure I got was around 78bar. Followed the instructions and the washers assembly as shown on the manual that came with it. Anyone know what it could be?
Need help with Huma reg
- Thread starter cfs916
- Start date
are you sure washers are stacked properly as if not they wont have the stiffness to have hi pressure
Upvote 0
Making sure you got the RIGHT diameter bevels and correct spool length replacement .... the IIRC 16 bevel thin/thick stack should work fine.
Unless you missed it .. in the 2 bags of bevels that come come from HuMa, one bag thin ones other bag thick. THEY MUST ALTERNATE on every pair )) (( )) (( )) (( )) ((
Unless you missed it .. in the 2 bags of bevels that come come from HuMa, one bag thin ones other bag thick. THEY MUST ALTERNATE on every pair )) (( )) (( )) (( )) ((
Upvote 0
Yes, i made sure i stacked them correctly. The extra high pressure only come with one bag of bevel washers. I will check the diameter of the washers when i get home. Dont think theres thick or thin but i will verify that as well, Thanks
Upvote 0