Need help with a AGT Vulcan

[mvonbeamer]

Hi everyone, I have a Vulcan 1 in 25 caliber and have shot several thousand pellets through it with no problems. I did notice the last time I shot it that it was shooting low. I figured I needed to clean the barrel so I did. After I was finished, I decided to shoot it and the first shot felt like no air came out. I removed the magazine and fire the pellet that was chambered and felt a strong puff of wind come out of the magazine well.

I put the mag back in an fired one more pellet and had the same issue with the puff of wind coming out of the mag well. I found a piece of a black o'ring on my shooting table so I'm sure I blew an O'ring. Anyone with a Vulcan have this issue who could point me to which O'ring I might have destroyed. 



Thanks

 

[Beach-gunner]

Beamer,



It sounds like the Breach O-ring needs to be replaced.

 

[Guest]

Beamer,



It sounds like the Breach O-ring needs to be replaced.

^^^this^^^

 

[likkitysplyt]

Agreed … it's the breech o-ring.

It should also be alot louder than it was if it is the breech oring.

That's a 1.5X6.5 oring for the .25 cal.

 

[zx10wall]

https://www.amazon.com/dp/B07D9N47TD/ref=cm_sw_r_cp_awdb_t1_Yr4tDb0HEN1MR

 

[mvonbeamer]

thanks everyone. It was a lot louder. Anyone know of any video's showing how to replace it. I'm sure I can figure it out but would be nice to see it done.

 

[mvonbeamer]

I know to some this will sound stupid. It the breech o-ring at the front of the barrel where it meets the pellet probe area. I removed the barrel and see two o-ring but it appears that another o-ring should be at the base of the barrel. Am I right?

 

[mvonbeamer]

Ok everyone, Thanks for the help. Once I figured out where the breech seal was, I was able to fix it. Thanks a million for the help..



Mike