Need help Extreme Big Bore Booster Pump

[SenseiSmash]

Good afternoon AGN,

I just purchased a booster pump from a memeber on here and USPS was a little rough with it causing the fill whip assemble to snap off of the fitting that threads into the Booster Pump.
I called Extreme Big Bore but they no longer have any inventory and are officially out of buisness.
Does anyone know where I can find this part or what its called? I have it circled in red on the far right bottom of the picture.

Thank you in advance.

 

[WorriedMan]

Many of those fill whips have threaded ends which accept an assortment of ends. I'd pull female quick-disconnect from undamaged end, then see if it will replace broken end. If so, might just need a generic fill whip from eBay, 10mm threaded ends. WM

 

[SenseiSmash]

Many of those fill whips have threaded ends which accept an assortment of ends. I'd pull female quick-disconnect from undamaged end, then see if it will replace broken end. If so, might just need a generic fill whip from eBay, 10mm threaded ends. WM

Unfortunately, the spot where the broken male end feed into the booster pump its quite a bit large diameter than the female QD end.

 

[Bladesx]

that is an Ayrtekk unit. try maddogstocks

 

[WorriedMan]

Unfortunately, the spot where the broken male end feed into the booster pump its quite a bit large diameter than the female QD end.

Sorry, figured worth a try. Hopefully, all works out for you. WM