My FX Crown trigger slides back and forth...Normal?

[CP1]

Hey guys...just noticed that my Crown's trigger slides back and forth maybe a 1/2" or less along the rail with the set screws in it. Is this normal for the trigger to loosely slide like that? I just noticed this. 

Thanks

 

[Bob_O]

Once you remove the stock you'll be able to access a small set screw. Once you get the trigger into the position you want, just snug it up. Don't over-tighten. I put mine all the way to the rear as I don't have large hands or long fingers. I get extra leverage that way. Keep in mind if you change the position from where ever it was set before, the trigger pull weight might need to be adjusted so it's like it was before.

 

[bzizzi373]

My Crown did the same thing, just needs tightened up.

 

[CP1]

BIG thanks to Bob O for private messaging with me. Very straightforward removing the stock and tightening the trigger, I actually slid it back too, shortening the reach from the thumbhole to the trigger.