custom inlet a manners to fit my drs pro and its awesome. now its a .25 and im shooting altaros 49.5 and at the same reg preasure and speeds as my panthera im only getting 6 shots on reg. is that normal because the plenum is smaller?
FX manners stock for my drs? dont mind if i do!
- Thread starter 920air
- Start date
Very cool, how difficult was the inlet? I have a 700 Manners stock around here somewhere with nothing to go into it.
Upvote 0
What reg pressure are you using? DRS pro has the tungsten hammer so your reg needs to be around 160-170b.
Upvote 0
it wasnt too difficult the drs is flat bottom so you just need a few defferant heights in a rectangle. but the drs plenum is wider than a aics mag and the magwell needs widening and its very tight without breaking through
Upvote 0
it came at 150 bar i put it at 160 and it got worse. its at 155 now. and i get 10 shots at 900 fps. but i want to be closer to 960
Upvote 0
First, Altaros slugs are designed to shoot right at 890-900fps. Second, DRS pro max out right around 900fps with those 50 grain Altaros.
Try 160 and gradually turn up the hammer to it hits the power sweet spot for 900fps. You likely have too much hammer.
Try 160 and gradually turn up the hammer to it hits the power sweet spot for 900fps. You likely have too much hammer.
Upvote 0
ok i will try that. i need it to do 12 shots minimum on a full tank. but idealy i would like 14. . my panthere shoots them soo good at 955. i just figured i would try n get the drs to do the same.
Upvote 0