M3 mags and cheek pieces for lefty
- Thread starter Airgunmann
- Start date
I'll get this done. The thing is that it was not just mirror the magazine..
Also the challenge is that I cannot text the left mag on my gun lol.
One week max
Also the challenge is that I cannot text the left mag on my gun lol.
One week max
Upvote 0
Orion beat me to it. I just completed my Fx mags and could mirror as well. Also, would not be able to test for operation. Would just be a simple case of reversing how the center wheel spring is wound as well.
Upvote 0
Upvote 0
Looked at that option but you would need to carry 5 mags to have the same capacity as 2 of the larger mags that's the down fall of that
Upvote 0
Beautiful work i have to write on 5 topics to send you a message, maybe this will reach you. Cheek rest for pp750, would love one thanks
Upvote 0
Ok I got everything together and mag is still fitting tight will need some more filing but looks like it should be good it is all doable with a Dremel and a file if you have a steady hand which I don't here are some pics I can explain more details if need be just ask I had to get two longer screws from hardware store where I put the plastic over the latch lastly I had to go quite deep with the notch in the one but stock piece and had to trim the small block in the center rear for clearance I believe that helps the mag stay straight the screw size is m3-.5x10 used a washer that measured just under .070 to space the blanking plug up and enlarged the gauge hole to 5/8 for clearance if you have a gauge in place the front piece would have to be 2 seperate pieces and metal removed where it would sit down in u could just follow the edges around where they were relieved on the opposite side still waiting on the left hand cheek piece and I'll have to air it up and run a couple mags through it yet to make sure fitment is good mk2 is do able also just has a different cheek piece 
Upvote 0
Here is a bottom pic it would look better using a piece of metal to cover the whole front piece if there isn't a gauge in place and metal painted black 
Upvote 0
Got the mag to fit well and snaps into place good could sand the pieces down and hit them with black and clear coat to get rid of the shiny metal parts maybe later looks like it will work fine now shouldn't have any troubles the probe looks to be lined up with the magazine hole draining what's left of the air and going to switch to a 300 bar bottle for him also figured might as well do that before I air it back up I feel like it is a success I will know for sure after running ba mag through it though
Upvote 0
It is no longer a tight fit before you had to push on the mag kind of hard to get it latch which I didn't like
Upvote 0
Well we went hunting several times now with his m3 left handed and it is working flawless he loves it now
Upvote 0