Lothar Walter Barrel For .22 Marauder
- Thread starter AirGunShooter
- Start date
2264-001
That is the old part number. Not sure if it will fit or if it is the same. I dont own any marauders, just 2 1322s both LW
That is the old part number. Not sure if it will fit or if it is the same. I dont own any marauders, just 2 1322s both LW
Upvote 0
I bought a 22 inch LW (stock is 20, up to 24 available), barrel from Roy at mountain air . He is Crosman authorized service center, located in Georgia. Great guy, cost was $275.00 and it took 3 months to get, but oh so worth the wait. He also provides new air stripper as barrel is slightly larger dia. than stk. Other than that, he has very few upgrade parts, but has all the stk. stuff.
Upvote 0
MR-022 For the crosman Mrod LW barrel. Around $100.
The 2264-001 is a misprint in the schematics. It never changed from Gen 1. It is 2263-001. That is the standard crosman barrel and around $40.
The 2264-001 is a misprint in the schematics. It never changed from Gen 1. It is 2263-001. That is the standard crosman barrel and around $40.
Upvote 0
Will the MR-022 fit in my Gen 1 .177 Breech? I’m guessing I’d need to swap out the bolt probe while I’m at it.
Upvote 0
Yes. You need barrel, bolt, barrel O-ring, and mag to convert calibers. You would want a Gen 1 bolt, but a Gen 2 might work OK. You could just sleave the 177 bolt to 22 with brass tubing.
Upvote 0
Cool. I shoot 25 Meter Bench Rest in .177. I’d like to try a 22 conversation and see how it goes at 50 Meters. Gun is regulated.
Upvote 0
You will probably want to raise the reg pressure some for 22 cal, and re-adjust hammer to the higher pressure.
Upvote 0