Little help for my friends Condor again

[wethy]

My friend is trying to quiet down his Condor it's 25 cal he got a hold of Talon tunes and they sold him some stuff he sent me what he bought but the bill only shows a partial explanation of the stuff. Here's what he got. Thought you guys can enlighten us on what we're getting into installing this stuff. I know the salesman said to just call if there are any problems but just trying to get on top of it.

Condor sound moderator 14 &

Condor/ Talon Hammer with sl

quick change top hat

If that doesn't make sense I can call him and ask exactly what it is or I can look up the part numbers. I just figured you guys would know what they are I'm assuming we're just installing a suppressor and a hammer spring? I know I've read on here so many times where people say take out the spring clean it and lightly lube it I assume that's what the hammer is thanks

 

[shambozzie]

You need to remove the bbl to change the hammer spring. Also remove bbl end cap and set aside. This is where the 14" moderator slide in and held by a grub screw. The top hat can be removed with 2 flat blade screw drivers . one on each side and pry up . insert Tonys qcth and press with a quarter part the way then dry fire.Decide if you want full blast or install on of the inserts. Button gun up and you should be good to go. No need to remove tank but be careful.

 

[davecole]

The moderator is self explanatory.

The hammer has an O-ring on the face of the end that makes contact with the delrin bolt. This reduces the smack noise the shooter hears. I don’t think it’s necessary to put any lube on the spring and I wouldn’t. There should be a small piece tape on one of the coils. This helps reduce the noise the spring resonates. 
The top hat allows easy and a more finite adjustment to velocity. I try to keep the power wheel at a minimum setting. By doing so, will give you a smoother trigger pull. 
My Condor preferred the JSB Kings 850 to 900 but your mileage may vary.