I got this REPR recently and when started tuning for speed of course I broke the oring in a very first ten minutes. Replaced as per specs, also did some polishing on the bevel washers.
Today after about 3-4 hundred shots in my club I left the Reg about 95 bars and when I got home the gauge shows 110. I remember the last 2-3 mags were some erratically speed I thought the barrel started fulling.
The Reg is not leaking, no hiss or any sound, assume the oring is not blown again.
20 ish bars raising within half an hour. What that means? It is not some conventional design, can this REPR Reg creep as well?
Edit:
I forgot to add that last week I was shooting .22 JSB MRD with a 350 mm barrel + 2x0.3 jets, and at 950 fps I didn't like the grouping at all.
Today I swap the barrel to 500mm and tuned for AA FT 16 gr, but the jets were still the 2x0.3. I could not lower the Reg below 90 bars probably because of small jets, the ES was erratical, but still,
These AA's beats the MRD grouping big time even with a "out of normal range" speeds of 950-980.
Swapping jets to 0.4 for next range day.
Today after about 3-4 hundred shots in my club I left the Reg about 95 bars and when I got home the gauge shows 110. I remember the last 2-3 mags were some erratically speed I thought the barrel started fulling.
The Reg is not leaking, no hiss or any sound, assume the oring is not blown again.
20 ish bars raising within half an hour. What that means? It is not some conventional design, can this REPR Reg creep as well?
Edit:
I forgot to add that last week I was shooting .22 JSB MRD with a 350 mm barrel + 2x0.3 jets, and at 950 fps I didn't like the grouping at all.
Today I swap the barrel to 500mm and tuned for AA FT 16 gr, but the jets were still the 2x0.3. I could not lower the Reg below 90 bars probably because of small jets, the ES was erratical, but still,
These AA's beats the MRD grouping big time even with a "out of normal range" speeds of 950-980.
Swapping jets to 0.4 for next range day.