Leshiy classic tune

[ShadyBrady]

Well, I finally ended up having a leak in my leshiy... now apparently a "leshiy classic". Considering I've been thwacking things with it since early 2018 with pretty much no problems (other than I buggered the hammer the second week I had it... long story) I'm more than pleased with the goblins service record. You could fill a warehouse with all the critters gobbo has un-alived .

I digress... last week I noticed she won't hold air at all, but the valve doesn't seemed smashed which was what I was assuming was the issue. I ordered a reseal kit and a new valve just in case, but figured while I'm at it I'll go ahead and upgrade to the huma reg and xl plenum or what not.

I'm shooting a 350mm barrel, and I'll be shooting either of these loads, probably whichever groups, most likely JSB. I'm hoping I can find a spot where they both perform reasonably well

Any advice on Reg/ HST setting? Any of you guys shooting mid/heavy .25 in yours? If so whacha set at?

 

[mtnGhost]

With that barrel, I shoot Hades at 880 and 34gr at 830. Reg is at or a little above 150 with 30-35 CCW on the hammer.

 

[fatmatic]

I kept reading that the leshiy doesn’t shoot slugs well? I’ve always wanted to try in mine but currently it’s not running either. Might have to get a reseal kit also

 

[ShadyBrady]

And you would be correct... I've tried more than a dozen. But apparently these are supposed to be sized down, so I'm willing to give it a whirl?
I ordered them from edgun west.

 

[ShadyBrady]

With that barrel, I shoot Hades at 880 and 34gr at 830. Reg is at or a little above 150 with 30-35 CCW on the hammer.

Thanks mtn that's mad handy. Saves me a lot of time when my tunes have at least a decent starting point

 

[ShadyBrady]

Update: a call to edgun west resolved leak in about... 40 seconds. Dude is a wizard
I got curious, ambitious or I'm not even sure what and broke a corner of the display board in the gauge trying to investigate for a non existant leak. Completely my boink up. Upgrading to meazy.

 

[ShadyBrady]

An update if anyone in airgunland stops by... I had to tune way...waaaaay down. To around 125 on the reg and about 12-15 on hst. When I try to tune much higher, seems to yield fiers. Pulling hard left. Buzzing like a whacked funny bone. Or your granddads springer.

 

[mtnGhost]

An update if anyone in airgunland stops by... I had to tune way...waaaaay down. To around 125 on the reg and about 12-15 on hst. When I try to tune much higher, seems to yield fiers. Pulling hard left. Buzzing like a whacked funny bone. Or your granddads springer.

Which moderator are you running? Check the alignment with the muzzle endcap.

 

[ShadyBrady]

Donnyfl. Seems gtg. Did end up bringing hst to 15. Gives Mr a nice even 10 bar per shot... so about 15 in the tank. Not sure on velocity atmosphere there's a crater in my chrono. I don't wanna talk about it.



I have the akula for the 350mm barrel on the way. More out of curiosity...the donnyfl works ok. Sidenote... I wish like hell I could get ahold of the huma leshiy pellet dispenser in .25.

the hades are super tight fit ... maybe that's some of it? They seem accurate enough though and hit like a truck

 

[ShadyBrady]

After replacing all the Orings and upgrading reg I figured id grab leshiy a few upgrades lol

 

[ShadyBrady]

Which moderator are you running? Check the alignment with the muzzle endcap.


Have you had any experience with either of these?