I have a 350mm 30cal with a valkyrie kit. I also have a Donny fl installed in some photo's as well. I haven't shot for groups as of yet but when the weather gets better I will. 
Leshiy 2. All done ✔️ 350mm 30cal
- Thread starter Jld1969
- Start date
I dig your setup. How's the clearance between the Ronin and the Valkyrie rail? Looks close. Are you just using the DonnyFL M14 Vulcan to 1/2"x20 Adapter? I can't seem to find the adapter on his site.
Upvote 0
The vulcom M14x1.25 will fit on the alpha barrel with the 30cal 350mm valkyrie kit it screws on the barrel and tightens up right to the hand guard perfect. Donny makes this size for his hole lineup if you don't see the size then just email Donny he will take care of you he's great at getting back to his customers fast. It's a great set up. I tested both the Donny ronin and the tishina 2 200 x 350mm that's the largest moderator Valkyrie makes and it's very quiet the Donny ronin is not as quiet but kinda close I believe the emperor is the equal in size and will be the quietest.
Upvote 0
Really nice looking now, how about showing us some targets ?
Holding off until the Delta Wolf is available.
Holding off until the Delta Wolf is available.
Upvote 0
@RonT
I haven't got out to shoot at all weather is bad in the east right now but yes I see other guys posting groups I can't wait to get out and see. I have my limited addition Delta wolf on order as well but looks like will be waiting a while before it's out.
I haven't got out to shoot at all weather is bad in the east right now but yes I see other guys posting groups I can't wait to get out and see. I have my limited addition Delta wolf on order as well but looks like will be waiting a while before it's out.
Upvote 0
@sonny it fits back into the factory box same size as the factory 350mm I just remove the moderator is all. Actual measurements I haven't done but it's the same I would say because it fits perfectly back in the box.
Upvote 0
@sonny, when I tried screwing on my M14 threaded Ronin directly to the barrel, it added about 2" to the overall length of the L2 compared to the 350mm factory shroud setup. I can measure again later tonight to get the exact difference in length if needed.
I put the factory 350mm shroud back on for now and am working to lower to reg to reduce the report at this preferred overall length if possible. I've got the reg down to 100bar but will likely decrease it further to 90 or 80bar. If that isn't as quiet as I want it, I'll try it with the Ronin again with the added length to see if helps some more.
Upvote 0
Looks Amazing!!! Mine is on order!Jld1969, so cool! I like your setup. Say, what’s that patterned cover you have on your barrel? Did you make it yourself? So trick!
Upvote 0