Kral Puncher Breaker leaking after I try to install Huma relator

[puthea]

When I put it back and refill it it make a sound like fart inside the tube can not fill it over 100 bar and suddenly the air was gone, anyone can help I live in Annandale,VA

 

[JimNM]

Take it apart, remove regulator. Reassemble as it was stock and see if it leaks. Then, carefully re-do the regulator assembly. See all f it leaks.

 

[Papy_Yosh]

it sounds like you have the regulator backward, I agree with @JimNM. take it apart and put it back together. Check the o-rings on the outside of the regulator that seals with the tank. use a light silicone touch on them when you put all of that together. Check this out too. https://youtu.be/-Tkj3MU18ps

 

[Keyman62421]

Make sure you're installing reg in proper direction

 

[davidsng]

I just installed a Huma in one of my guns. I was getting leaks and also could not figure out why. In the end, I found it was an o-ring in the separating the plenum and the atmospheric breathing hole was missing. ( I don't know if it did not come with it, or I lost it without knowing it.) I went down to a local hardware store and found one that sort of fit, but it worked. Just an idea.

 

[Elbowgrease]

Not sure about the kral but some airguns will give you a hard time airing up from empty without taking the hammer pressure off of the valve. Try cocking it first and then air it up.

 

[puthea]

Thank you guys for helping me I will try and will let you know, big thanks 

 

[puthea]

It woks now just cocking before I refill it and no sign of leaking yet and can’t wait to go shoot again with regulator on yayy, thanks all