Hello All, I am a new member and am looking for some assistance finding a barrel shroud for my NP-03 (in .177 if it matters). Mine snapped like someone else had happen in this forum. The shroud is paper thin and it was a minor drop that snapped it. I don't feel confident with my 0DB moderator installed and not having a shroud or a barrel band. I have a feeling the barrel will bend easily without some type of support.
I checked with Pyramyd and Air Gun Depot and they didn't have the shroud or a barrel band to connect it to the air tank. I tried emailing Kral and the email came back as the email address apparently does not exist ([email protected]). Someone had mentioned in a different thread that Thammer might have one but I am new and can't send a direct message at this point. I have a couple 3d printers so I guess worst case I can print a barrel band if I can find a STL or sit down and design one in Fusion360. Thanks for any assistance or advise.
I checked with Pyramyd and Air Gun Depot and they didn't have the shroud or a barrel band to connect it to the air tank. I tried emailing Kral and the email came back as the email address apparently does not exist ([email protected]). Someone had mentioned in a different thread that Thammer might have one but I am new and can't send a direct message at this point. I have a couple 3d printers so I guess worst case I can print a barrel band if I can find a STL or sit down and design one in Fusion360. Thanks for any assistance or advise.
