AEA karma eq mods

[gizmo1974]

just bought a same as new karma eq from a member its 22 cal been talking to pj in florida super helpfull guy he is from what i gathered aea builds this gun but to donnly fl specks tore it part way apart the 500cc tank is way to long for me so i am cuting it in half building a shorter gun from it factroy there 13 7/8 long cuting it down to 6 and 3/4 it will go from 500cc to 250cc i am ok with that then i going to take 6 inchs off the barrle and shroude factroy is 600mm

 

[gizmo1974]

i wish they made them factroy like this katra

 

[Trucker3573]

As far as the tank goes AEA has smaller ones. I would try to see if one of those would fit ? Wouldn’t surprise me if they were the same specs. Maybe pj could answer that. Be way easier and safer than cutting and putting back together.

 

[blackdog899]

The most important Mod for the Karma EQ would be
an aftermarket entire trigger system.

not a little $0.001 little black plastic block that was Karma’s upgrade

 

[Dstrac]

just bought a same as new karma eq from a member its 22 cal been talking to pj in florida super helpfull guy he is from what i gathered aea builds this gun but to donnly fl specks tore it part way apart the 500cc tank is way to long for me so i am cuting it in half building a shorter gun from it factroy there 13 7/8 long cuting it down to 6 and 3/4 it will go from 500cc to 250cc i am ok with that then i going to take 6 inchs off the barrle and shroude factroy is 600mm View attachment 575528

I like the idea, 250cc is a standard length aea 52mm air tube, so theres no need to cut and re-thread the existing tank. It's probably cheaper buying it. You just need the barrel and shroud cut down and threaded. For refrence my s45 has a 250cc rear tank on it and the tube itself measures 8 7/8".

 

[gizmo1974]

thanks for the replys i talked to pj he has a 10.5 in stock and will be geting in a 7 inch he did say these are aea gun parts i decided not to cut my tank down for haveing a hier shot count the trigger is a nother story one i got seams like these are slop in it and there reg part that ataches to action mine has a little play in it

 

[Dstrac]

thanks for the replys i talked to pj he has a 10.5 in stock and will be geting in a 7 inch he did say these are aea gun parts i decided not to cut my tank down for haveing a hier shot count the trigger is a nother story one i got seams like these are slop in it and there reg part that ataches to action mine has a little play in it View attachment 575719

There is a set screw going through the trigger gaurd that presses against the regulator housing. I tighten up the set screw on mine to stop the flex

 

[gizmo1974]

thank you i was woundering about that so it should be in frount of trigger shoe going up throught trigger guard mine has maby few thousands play in it i try and find screw and tighten it up