FX Is anyone familiar with the o-ring size that should fit inside the FX IMPACT hammer spring adjuster to keep it from unscrewing?

[Maizen]

I remember someone mentioned it to me…but I was never told what size o-ring. Does anyone have that info? Could you show me a picture so I can copy it?

Should I also apply a toothpick end sized drop of blue loctite or vibratite when installing?


Thanks in advance.

 

[Bigragu]

2 x 1.5 o ring size is all I can provide.

You will need to remove your power wheel to do this mod, so you can push the oval piece far enough to the right while you unscrew the adjuster screw outwards towards the left. Clean all old thread locking solvents off of the screw. As you re thread he screw back on, carefully shove that o ring inside the middle of the oval slider, and hold the o ring vertical as the adjustment screw finds it’s way thru the o ring. You will see that it takes more effort to turn the adjuster screw thru the o ring, which should answer your question of wether you should apply additional thread locker with this o ring mod.

 

[Maizen]

2 x 1.5 o ring size is all I can provide.

You will need to remove your power wheel to do this mod, so you can push the oval piece far enough to the right while you unscrew the adjuster screw outwards towards the left. Clean all old thread locking solvents off of the screw. As you re thread he screw back on, carefully shove that o ring inside the middle of the oval slider, and hold the o ring vertical as the adjustment screw finds it’s way thru the o ring. You will see that it takes more effort to turn the adjuster screw thru the o ring, which should answer your question of wether you should apply additional thread locker with this o ring mod.

Thanks

 

[Ydunn.223]

I think I've seen someone use a C-clip at one time but I do not know what size it was.
If I remember correctly the C-Clip went on the wheel adjuster part and not the metal
threaded part it clipped on and did not move although you would need some needle
nose to remove it.