I bought this NIB , used on eBay, Induro 75CP. for 200.00. WOW, what a beast. Got the LB52 Artcise ballhead from Amazon, rated for 66 pounds. The panning clamp that comes with is will not fit picatinny. Even though you can get adapters Arca/Picatinny. I wanted a clamp that would fit both. The only I could find was over a hundred dollar. Got on eBay & found this one.
Picatinny Lever Release Panning Clamp with 3/8" Screw ARCA Standard for Tripods | eBay
Had to heat the neck of the ball , they used Loctite. Then when I got it off the new clamp did not fit , as there are two lugs on top of the neck of the ball head that fits into the bottom of the panning clamp. But a little metal removal from the panning clamp, via Dremel, fits like a glove. The panning clamp will not attach to the picatinny that is on the Impact, hits the bottle. I had to add a riser to put the top of the clamp below the bottle. I wanted to keep my hookup minimal, after trying several Picatinny risers that I had in the junk box, this one fit. But another glitch, the wingnut on this little riser was in the way of the panning clam. So I removed the wingnut & found a 10/32 nut.
Picatinny Lever Release Panning Clamp with 3/8" Screw ARCA Standard for Tripods | eBay
Had to heat the neck of the ball , they used Loctite. Then when I got it off the new clamp did not fit , as there are two lugs on top of the neck of the ball head that fits into the bottom of the panning clamp. But a little metal removal from the panning clamp, via Dremel, fits like a glove. The panning clamp will not attach to the picatinny that is on the Impact, hits the bottle. I had to add a riser to put the top of the clamp below the bottle. I wanted to keep my hookup minimal, after trying several Picatinny risers that I had in the junk box, this one fit. But another glitch, the wingnut on this little riser was in the way of the panning clam. So I removed the wingnut & found a 10/32 nut.
