indicative fps for .25 FX Hybrids and quality..

[2L8]

osmodraama,

DL Classic with 600mm STX standard pellet liner shooting @950fps

 

[FX-USA]

A little low pressure air or vacuum should clear that up at the factory. They should have something to clear out the junk before it leaves the factory.

Appreciate the post about this as our standards are to really clear out the flashing before packaging. We're looking into this!

 

[osmodraama]

A little low pressure air or vacuum should clear that up at the factory. They should have something to clear out the junk before it leaves the factory.

Appreciate the post about this as our standards are to really clear out the flashing before packaging. We're looking into this!

That's nice to hear! I just shooting some test shots and I notice that flashing is not only bad thing.. when the top of hollow point was not finished looking and clean.. the accuracy was poor and the fps varied a lot.

 

[osmodraama]

here are some results of four hours of test shooting..

45m (49yd) = very good accuracy

65m (71yd) = ok accuracy

+70m (76yd) = something happened and the accuracy went really bad..

and I really try many many different fps and pressures etc.

I got the best results at fps 990 - 1020.. lower velocities than those caused even more scattering.. 950 - 970fps was very bad.. 

I am a novice, I know that, but still this is something strange if you compare to other slugs and pellets and harmonic tuning is more difficult.

Those pictures are taken from the best shots so .. maybe someone could help me and tell me why this is happening..

I think one possible reason is poorly finished hollow point.. because it affects the aerodynamic and I notice many bad "flyers"..