So I bought my impact with a slug pin probe installed, and was having issues with shooting pellets like the hades with deep skirts that wouldn’t load fully past the transfer port hole. I bought a huma high flow slug/pellet probe to replace it and seat the pellets to the proper depth. At the same time I bought that, I bought the huma single shot loader, and used this setup for the past month or so without issues. Fast forward to today. I decided to do some back yard plinking, and load up the magazine for ease of cycling. I insert the magazine, and hmmm. The pellet probe gets stuck going into the transfer port. At first, I though the magazine was holding it up, but it’s making it through the magazine, and then getting caught up on the lip of the transfer port opening. Confused, I remove the magazine, and try without it in. Probe goes right into the transfer port. Must be the magazine right? So I lessen the spring pressure on the magazine, and same problem. Try my other magazine, same problem. At this point, I fiddle around with the probe, and find out if you put your finger against the probe while pushing the bolt forward, it catches the side of the transfer port. I remember the original fx probe causing similar issues, and they updated it with a chamfered front to alleviate the problem. The huma doesn’t have this chamfer. Is this my problem? Or am I missing something else?