Question: is there a adjustable cheek riser that is compatible with the K&L probe block? Any of you fellas running a combination that works?
Impact M3 K&L probe block and cheek rest
- Thread starter Meanadidas
- Start date
What are your concerns?I have k&l cheek risers and probe blocks on all my impacts? And butt pads
Upvote 0
What are your concerns?I have k&l cheek risers and probe blocks on all my impacts? And butt pads
I was concerned that the probe block would rub/hit the cheek parts located inside the frame.
Upvote 0
The KL V2 cheek riser doesn't have interfere issues bc it mounts on top of the frame vs an insert inside of the butt area. Granted, I have to take it off if I want to change my probe but no rubbing issues.
Upvote 0
I use the ST cheek riser rest with the K&L probe block on both my impacts, as I like the convenience of easy pellet probe removal without having to remove anything. But, the trade off is you’ll have to carefully mill off almost half of the ST inner piece and re tap two new mounting holes for the outer adjustment screws.
The turn out on mine is the K&L probe block is like a strong 1/32” above the ST inner block and completely doesn’t collide or rub on the bottom of the pellet probe block as I cycle the cocking action. Very smooth.
Careful precise measuring, planning your steps carefully, it can be done with basic hand tools. This is for sure a measure twice cut once job, but well worth it.
if you decide you want to pursue this mod to the ST cheek rest shoot me a pm as I took down meticulous notes in case I had to do this again
The turn out on mine is the K&L probe block is like a strong 1/32” above the ST inner block and completely doesn’t collide or rub on the bottom of the pellet probe block as I cycle the cocking action. Very smooth.
Careful precise measuring, planning your steps carefully, it can be done with basic hand tools. This is for sure a measure twice cut once job, but well worth it.
if you decide you want to pursue this mod to the ST cheek rest shoot me a pm as I took down meticulous notes in case I had to do this again
Upvote 0
Couldn't tell you.....after waiting 8 weeks for K&L to make my cheekpiece I cancelled the order.
Personally, I like the design of the new PRS cheek piece more anyhow, and it is ambidextrous and easily adjusted.
Personally, I like the design of the new PRS cheek piece more anyhow, and it is ambidextrous and easily adjusted.
Upvote 0