Down and dirty:
I broke it down far enough to remove the rear block to take some measurements for a custom barrel.
I put it back together and there was an air leak coming from the trigger well.
I used Mr. Rowe's vids to service the valve, only found one damaged o-ring on the valve tube, but replaced both.
partial reassemble as per vid. to conduct leak test, installed air tank, no leak, then I removed the tank and after a min. or so I heard it leak off rapidly
I thought maybe it was normal for the bleed off after removing the tank so I installed the bottle again to see, but this time leaking heavily from the rear of the trigger well, that's where the reg is but I haven't touched the reg
Is this issue a procedural thing that I caused by doing something out of sequence or is there something else going on?
Any guidance/assistance appreciated.
Please no recommendations to take to AOA for service, I'm done with them for service.
Thanks!
I broke it down far enough to remove the rear block to take some measurements for a custom barrel.
I put it back together and there was an air leak coming from the trigger well.
I used Mr. Rowe's vids to service the valve, only found one damaged o-ring on the valve tube, but replaced both.
partial reassemble as per vid. to conduct leak test, installed air tank, no leak, then I removed the tank and after a min. or so I heard it leak off rapidly
I thought maybe it was normal for the bleed off after removing the tank so I installed the bottle again to see, but this time leaking heavily from the rear of the trigger well, that's where the reg is but I haven't touched the reg
Is this issue a procedural thing that I caused by doing something out of sequence or is there something else going on?
Any guidance/assistance appreciated.
Please no recommendations to take to AOA for service, I'm done with them for service.
Thanks!