Impact barrel sleeve oring
- Thread starter DrOcean
- Start date
Well, actually I didn't look further into the adapter. I saw that groove and figured that's where it belonged....it fits perfectly in there.
I haven't tried to reinsert the liner because I cannot get the 22 adapter into the longer sleeve.
I won't hijack your thread with that problem though....I'll start a new one.
I haven't tried to reinsert the liner because I cannot get the 22 adapter into the longer sleeve.
I won't hijack your thread with that problem though....I'll start a new one.
Upvote 0
Barrel / TP adapter inner liner oring size as fallow:
.177 7X1
.22 8X1
.25 9X1
.30 10.1
Liner lock / 1/2’ 20 jam nut:
all caliber have there own liner lock in relation to the OD of the liner.
.177 7X1
.22 8X1
.25 9X1
.30 10.1
Liner lock / 1/2’ 20 jam nut:
all caliber have there own liner lock in relation to the OD of the liner.
Upvote 0
Hi, Impact newby here. I new gun and had to install a CF sleeve on my M3 ofcourse.22 liner internals and assembly video
Correction on the liner OD orings they are 4.42X2.62mm I recommend 3 oring or more.
Note: .25 .30 cal there is no internal oring on the jam sleeve— wall thickness doesn’t support oring groove.
. So long story short that adapter O-ring came out with the 3 barrel o-rings. To fix it from what I read here I'm looking at taking the barrel apart or do I leave it as is (no sure what that oring does).What is needed to get the barrel and the stainless piece apart? What kind of glue is in there? would a heatgun be enough or is a torch needed?
any help is welcome here. Thanks in advance.
Last edited:
Upvote 0