I have Fx field tool idea

[Mrshosted]

I've had a this idea for some time and today I had a few moments to draw it out. Take a look and tell me what you think. I'm sure there's room for improvement and I welcome the ideas. I wanted to keep it at the business card size 2"x3.5"

The things on it now are,

-wrench's 5.5mm to 9mm

-6mm-6.5mm go/no go gage for setting up the c1

-34mm pellet probe depth set gage

-pellet head sizer .304 to.297 ( the proto type will be the .30 caliber)

-special wrench for the liner lock nut

-measuring tool for the hammer set screw

-and a bottle opener

-and hole in the corner for a key ring

If this works out to be something we in the airgun community would like I'll get it laser cut out for very high quality unit. probably out of stainless or mild steel and have it harden.

I welcome feed back good and bad.

Mont

 

[Bigragu]

Get with ELIS573 and make a slim magnetic two piece case for this that is magnetized to hold the pieces shut, like he does his speed loaders. Inside the case the form of your plates outline will be cut out so it nestles itself in there. This case it should also hold the three Allen wrenches- to adjust the reg, adjust the hammer spring, and to remove the pellet probe for caliber changes. Along with your tool, you’ll have an all in one “kit”. 

As far as your idea, great job! Maybe somewhere on the plate add a half round, about the size of a half a dime, to remove the turrets on a lot of the popular scopes that have a slot on the turret locking caps.

you can then loosen and remove that locking cap, lift the turret, and re set to zero. 

 

[GeneT]

Get rid of the bottle opener, unless you can make it an inboard 'hole style' - you will forever regret that sharp hook. 

GsT

 

[Mrshosted]

Both great suggestions. I'll work something in to it for scope adjustments. The bottle opener was only put on to fill space. Ill think on it for now, maybe a design change for it may come in the future. Thank you for great idea's Mont

 

[Glem.Chally]

What are the 5.5-9mm wrenches for? I like the liner lock tool.

 

[Mrshosted]

What are the 5.5-9mm wrenches for? I like the liner lock tool.

I thought they might be handy for small jobs. Like shooting stand adjustments, scope ring install or moving. Maybe for a friends problem or anything just in case. But nothing related to the Impact that I know of.

 

[dwilson050]

Nice job Monte. I agree, get rid of the bottle opener and add a half round for the scope turret. Also a good idea @bigragu had for a 2 piece magnetic case with a couple of Allen Wrenches. Well done brother! -Dave

 

[Glem.Chally]

What are the 5.5-9mm wrenches for? I like the liner lock tool.

I thought they might be handy for small jobs. Like shooting stand adjustments, scope ring install or moving. Maybe for a friends problem or anything just in case. But nothing related to the Impact that I know of.

Yeah totally, I like the idea! What about 1/4 hex then you can use a small set of bits from 2-5mm if needed?