HW97 disassemble
- Thread starter vinny
- Start date
I have done a lot of them. I would say yes. More importantly, depending upon the power you are going back with, most likely one will be needed for reassembly.
Upvote 0
They can be done without a compressor but quite tricky. Those with exoerience can get away without but if your new at this, I would highly recomend one !!! If the trigger block slips while compressing that spring by hand, the sharp edges can take a nice fillet out of your hand......I know......
Upvote 0
I'm the guy that hardly ever uses a spring compressor.
But....
For a new production HW97, I would DEFINITELY recommend one. I done one a couple months back and it had quite a bit of preload. And a slip here can ding the mating faces of the receiver plug, and cause all sorts of problems. Be careful, and have a plan before you start.
But....
For a new production HW97, I would DEFINITELY recommend one. I done one a couple months back and it had quite a bit of preload. And a slip here can ding the mating faces of the receiver plug, and cause all sorts of problems. Be careful, and have a plan before you start.
Upvote 0