How to degas Benjamin kratos

[max-7]

Does the Marauder tool work on the Kratos?

I not what tool do I need? 

Also the fill port is too deep inside the stock and difficult to release the fill hose

It needs a 1/2 inch longer fitting

Does anyone know where to get one?

 

[Odoyle]

You can connect your fill hose and crack it open till you hear the pressurized click then STOP! and close it then SLOWLY! open the bleed valve till you hear it SLIGHTLY hiss THEN LET GO walk away and let it piss all the air out slowly and go make a sandwich.

After you finished the sandwich and stopped hissing. Check manometer is at zero then Disconnect and fire it in your rubbish can several times to see if anything moves around to be sure there's zero air in it.

You can also try and carefully loosen-crack the manometer JUST A LITTLE! just to break the seal to let it leak all out there too or have fun shoot stuff to not waste the air just fire the gun till empty.

 

[thammer]

There should be an Allen head grub screw near the fill nipple. Loosen until it begins to hiss and let it bleed out. The Cayden and Akela have one near the full nipple as well. A Donnyfl extended foster quick disconnect is what you need to make connecting to the fill nipple easier. 

https://donnyfl.com/products/stainless-steel-extended-quick-disconnect-with-foster-fitting

 

[max-7]

Thanks very much

 

[pnwairgunner]

The bleed screw On the Kratos is the Allen head bolt beside the manometer (the air gauge). Loosen it slowly until you hear air escaping and then just let it do it’s thing til it’s empty. Takes a minute or two if the tank is full. Do not unscrew it all the way. Dry fire one time after it is empty. 

 

[Odoyle]

That's good to know! Thanks!

 

[TonyG]

I just keep learning great stuff on this site, thanks guys

 

[CyberDyneSystems]

Ah, that's very helpful!