How do you "clamp" a Fx Carbon Fiber Bottle ? making own vise jaws
- Thread starter airgun14
- Start date
If you are going to buy a tool for removing oil filters, that would be my choice, try and find one that is made for motorcycles or other small engines. It will be a much better fit than a car-sized one. The tool that will fit hole in question is called a Tommy Bar. Anything like a large nail or Allen key should suffice.
Upvote 0
My digital calipers crapped out so by simply eyeballing with an old wooden ruler it's just about 1/8" Maybe a hair smaller like 7/64" diameter 2 HAIRS LARGER THAN THE WIDTH OF A NICKEL and 9/32" deep stuck a paperclip then measured how deep it went in. JUST EYEBALLING IT NOW. Yo!
Upvote 0
thanks, great ideas, ..
but the hole only 2.78mm (7/64"), I thought it was at least 1/8" (3.175mm) ?
but the hole only 2.78mm (7/64"), I thought it was at least 1/8" (3.175mm) ?
Upvote 0