My reg was repeating within 25psi. Whatever inconsistency there was, wasn’t very noticeable on my gauge. I think if I want to be any more picky with the reg I’m going to have to get a digital gauge.
I believe my next step is a stronger valve return spring.
does anybody know the measurements of the oem spring?
My reg was repeating within 25psi. Whatever inconsistency there was, wasn’t very noticeable on my gauge. I think if I want to be any more picky with the reg I’m going to have to get a digital gauge.
I believe my next step is a stronger valve return spring.
does anybody know the measurements of the oem spring?
You have put a peek seat in your reg. It may take some brake in time to properly seal.
I suggest not to do things in hurry.
As far as OEM valve spring is concerned I understand that you already have it. So what is the point of asking the specs of OEM valve spring.
Further you might need just a bit stiffer spring. You are running the gun without balanced valve that I have installed. Due to that balanced valve high strength valve spring is needed. Since you have not made this modification, you just need a bit harder spring to reduce the spread.
Bhaur
My reg was repeating within 25psi. Whatever inconsistency there was, wasn’t very noticeable on my gauge. I think if I want to be any more picky with the reg I’m going to have to get a digital gauge.
I believe my next step is a stronger valve return spring.
does anybody know the measurements of the oem spring?
You have put a peek seat in your reg. It may take some brake in time to properly seal.
I suggest not to do things in hurry.
As far as OEM valve spring is concerned I understand that you already have it. So what is the point of asking the specs of OEM valve spring.
Further you might need just a bit stiffer spring. You are running the gun without balanced valve that I have installed. Due to that balanced valve high strength valve spring is needed. Since you have not made this modification, you just need a bit harder spring to reduce the spread.
Bhaur
My reg was repeating within 25psi. Whatever inconsistency there was, wasn’t very noticeable on my gauge. I think if I want to be any more picky with the reg I’m going to have to get a digital gauge.
I believe my next step is a stronger valve return spring.
does anybody know the measurements of the oem spring?
You have put a peek seat in your reg. It may take some brake in time to properly seal.
I suggest not to do things in hurry.
As far as OEM valve spring is concerned I understand that you already have it. So what is the point of asking the specs of OEM valve spring.
Further you might need just a bit stiffer spring. You are running the gun without balanced valve that I have installed. Due to that balanced valve high strength valve spring is needed. Since you have not made this modification, you just need a bit harder spring to reduce the spread.
Bhaur
On your balanced valve, did you have to go to a stronger valve spring?