Hello,
What is the thread size for the RAW pressure gauge? Any recommendations?
Thanks in advance
What is the thread size for the RAW pressure gauge? Any recommendations?
Thanks in advance
RAW Rapid HM1000x Pressure Gauge
- Thread starter Sell682
- Start date
Correct, the gauges are 1/8 BSPP (British Standard Parallel Pipe). To fit the stock or the chassis, the max outside diameter of the gauge should be 1" or 25mm and no larger.
Upvote 0
Provided SF wheel clearance is a non issue ?
I've used TAYLOR 3k gauges for a few years now.
Also used the slightly larger and taller WICA gauges
With a chassis the big Tayor works equally well.
* A simple thread chase on the V block threads to 1/8-27 npt tap and then teflon tape your golden with the big taylor
I've used TAYLOR 3k gauges for a few years now.
Also used the slightly larger and taller WICA gauges
With a chassis the big Tayor works equally well.
* A simple thread chase on the V block threads to 1/8-27 npt tap and then teflon tape your golden with the big taylor
Upvote 0
I have 3 of their 25mm pro gauges (same as the current 28mm ones they sell) and they work very well. These are out of production. I have tried 2 of their cheaper 25mm gauges, and had quality issues with both, as I have read others did too. Until Sekhmet works out their quality problems, I cannot recommend their cheaper gauges at this time.
For now, I will just use standard analog gauges...
Upvote 0
