G
Guest
Guest
What I've Done Thus Far:
1. I emailed Hill and explained the situation but we have a time difference of nine hours so it'll take a day
2. Followed the Hill-produced video and checked the 'ball' and 'bullet' seals at the ends of the tubes coming out of the cylinder head, they are OKay.
3. Tried to buy the "EC-3000 100 Hour Full Service Kit" but my CC won't go through for an international order, later I'll call the CC
4. Burst discs are okay
Notes:
*did not remove cylinder head to inspect o-rings because I do not have replacement part on-hand at this time
* machine has 16 hours on it only filling a Taipan and RTI Compact
*oil level is fine and recently changed
*silicone level is topped off
Am I missing something obvious?
1. I emailed Hill and explained the situation but we have a time difference of nine hours so it'll take a day
2. Followed the Hill-produced video and checked the 'ball' and 'bullet' seals at the ends of the tubes coming out of the cylinder head, they are OKay.
3. Tried to buy the "EC-3000 100 Hour Full Service Kit" but my CC won't go through for an international order, later I'll call the CC
4. Burst discs are okay
Notes:
*did not remove cylinder head to inspect o-rings because I do not have replacement part on-hand at this time
* machine has 16 hours on it only filling a Taipan and RTI Compact
*oil level is fine and recently changed
*silicone level is topped off
Am I missing something obvious?