Tuning Help my crown has a leak😪 [Fixed]

[2D1C]

Dry firing full trying to bleed the reg did this to me, the valve stem blew throw the valve seal and hit the bottle valve.........POOF I needed a change of clothes. The boys above know WAY more the me ok? But I wonder if the seal and stem should be replaced.

 

[Redick]

Dry firing full trying to bleed the reg did this to me, the valve stem blew throw the valve seal and hit the bottle valve.........POOF I needed a change of clothes. The boys above know WAY more the me ok? But I wonder if the seal and stem should be replaced.

I ordered new stem, stem spring and valve seat today we will see

 

[Redick]

Ok interesting find on the Crown leak. If I bottom out the regulator adjustment the Crown holds air just fine. And if I screw out any amount air rushing through barrel again.? WTF!?

 

[Jayson]

Bottom out? What does your reg gauge say? If that is clockwise? that would be close to blocked? If your valve stem is not in the view hole as shown before it can not seal! You might need to send that bad boy out? I’m trying to understand why you are messing with the reg when your valve is clearly not seated?. 

 

[tor47]

On the picture where you are looking down the hole, is that an O-ring visible? I have never changed it on mine, but as far as I know there is only supposed to be an O-ring on the seat itself, not in the hole where the seat is supposed to be. If that is the hole without seat installed, I believe there should be no O-ring there. Do not take my word for it, but I would dobble check that.

 

[Redick]

On the picture where you are looking down the hole, is that an O-ring visible? I have never changed it on mine, but as far as I know there is only supposed to be an O-ring on the seat itself, not in the hole where the seat is supposed to be. If that is the hole without seat installed, I believe there should be no O-ring there. Do not take my word for it, but I would dobble check that.

It's grease

 

[Redick]

Post updated