HELP! 2 new huma regulators

[Seth0764]

I got 2 new regulators from aoa for my bullboss and bt65. The one for my bt65 has a screw in the end where you adjust the bar setting. The screw is only finger tight. Anyone know if this is normal?

 

[sirk]

this should answer your questions.
http://foto.huma-air.com/foto/how%20to%20adjust%20the%20regulator%20pressure.pdf

according to that document it is a flow restrictor, it prevents dirt entering the reg. 
it is not what changes the reg output setting so you just adjust it the way it tells you in the doc. 2turns back from all the way in roughly. do not touch the brass bit.

 

[Seth0764]

Only one has this screw. 

 

[sirk]

man go and grab another standard M3 bolt and add it if you like identical sisters. if you dont want it wide open.
or remove it from the second. it should not matter.
did you read the document it is very clear near the end.

back to your original question. yes it is normal it is supposed to be loose if it is there the clear instruction say undo it 2 full turns. if it is not there then it is not there so it cant fall out
LOL

 

[wyshadow]

B4 you install the reg, tie a fishing line to that screw. The fishing line will make it easier to pull the reg out if you need to adjust it

 

[hasenpfeffer]

The reg is installed with that screw facing into the cylinder.

 

[Imold]

Seth let us know how they worked in each one, I have the same two as you but I've hesitated putting in the regulators because they both shoot good now.

 

[Seth0764]

"Imold"Seth let us know how they worked in each one, I have the same two as you but I've hesitated putting in the regulators because they both shoot good now.

This is how my bt65 is shooting with the regulator at 160 bar. 50 fpe shooting the king heavy mk2 es 7 sd 3. 817 fps. I have not messed with the hammer spring yet. Is like to see 850 fps