As title, my springer keep giving me a high left group after re-zero few shots, found out that my scope rotated to the left no matter how tight I tighten the screw
Other Have to zero the scope after 5-6 shots on springer because scope rotated- SOLVED
- Thread starter Mike CT
- Start date
There are square cushion pads between the ring and scope that made the scope rotated. After removed and cleared all the glue, tightened those screws as hard as possible, its good to go now
Upvote 0
Put one layer of masking tape on the bottom ring halves. Tighten to 18 inch pounds. Unless they are oversized rings or have been lapped oversize it will not move. Or, get a set of Burris Signature Rings with Inserts. Over torque the rings and you will ruin a scope sooner or later. Cheap rings are not a bargain.
Upvote 0
I just picked one from Amazon. Be sure to relax it to zero when not in use. The one above should work fine.
Upvote 0