Hi Everyone,
I am pretty new to all this but do feel I am pretty mechanically inclined.
I have had this compressor for about two months now. I have filled my 100cc tank three times to 310 bars and everything has worked just fine, topped off in around 30-45 minutes.
Sunday I went to top off my tank and after 2 1/12 hours it would never go over 80 bars. So reset the system and I put in the test prob and let it start again and still not over 80 bars, it will fill to 70 in around 15 minutes but takes and other 20 minutes to get to 80 and just seems to never go past that, no matter how long I let it run. (Side noted yes my auto shut off is set to 310 bars and the compressor never auto shut off because it never gets to 310 bars)
So I thought maybe it has a leak somewhere, left the test prob in and the compressor gauge showing 80 bars, turned off the compressor to listen for leaks and couldn't here anything. Went and found a water sprayer and mixed up some soap and water to spray on all the connections, no bubbles anywhere. I let it seat for 3 hour and still never dropped below 80 bars.
Any one have any other ideas I can look into?
Thanks for looking
Dave
I am pretty new to all this but do feel I am pretty mechanically inclined.
I have had this compressor for about two months now. I have filled my 100cc tank three times to 310 bars and everything has worked just fine, topped off in around 30-45 minutes.
Sunday I went to top off my tank and after 2 1/12 hours it would never go over 80 bars. So reset the system and I put in the test prob and let it start again and still not over 80 bars, it will fill to 70 in around 15 minutes but takes and other 20 minutes to get to 80 and just seems to never go past that, no matter how long I let it run. (Side noted yes my auto shut off is set to 310 bars and the compressor never auto shut off because it never gets to 310 bars)
So I thought maybe it has a leak somewhere, left the test prob in and the compressor gauge showing 80 bars, turned off the compressor to listen for leaks and couldn't here anything. Went and found a water sprayer and mixed up some soap and water to spray on all the connections, no bubbles anywhere. I let it seat for 3 hour and still never dropped below 80 bars.
Any one have any other ideas I can look into?
Thanks for looking
Dave