does anyone happen to have the screw dimensions for the stop plates on the 95/striker/edge/etc.? my screws must not have been tight enough, as the pressure from my scope mount snapped the screws in half about 500 shots in.
I would just use the scope stop threaded screw hole and use that hole for the rear scope stop roll pin from Sportsmatch mounts or the threaded stop grubscrew from UTG or other generic rings or just use BKL 1 Piece .007 droop compensated mounts no scope stop needed whatsoever.
Use a scope stop. Email Hatsan and ask them for a Magnum scope stop. Gamo also has them. The one on the rifle is from Hatsan the other a gamo![]()
![]()
![]()
![]()
![]()
![]()