Has anyone tried to adjust their Hatsan Sortie or Barrage for magazine feed and cocking problems? I talked to Hatsan Technical and they told me where the adjusting screws are located and gave me some directions. There are apparently two adjustments you can make. Adjusting two screws that may interact can be difficult so I tried a statistical adjustment sequence. It appears that I was successful as the Barrage operates very well now after the adjustments. I am curious if anyone else has tried to adjust their Barrage or Sortie and what the results were.
Hatsan Sortie and Barrage Adjustments
- Thread starter kpaoletti
- Start date
So far, my reconditioned Sortie I bought from Hatsan USA, is working fine. Have not put a chrono on it yet, and a little disappointed in the shot count, but it is a small air tube. I put a green laser on mine, and shoot targets holding it in my lap, sitting in my chair. FUN!
Upvote 0