Hello. I'm new to this forum, so I hope I'm in the right place. I have a .25 Hatsan Invader with less than 500 pellets shot through it. Now, it's starting to shot 2 pellets, in succession, with one pull of the trigger. It happens at least once during shooting a full magazine. Any help would be greatly appreciated if anyone has had the same problem or knows anything about this.
Hatsan Invader double firing
- Thread starter Rileyroo
- Start date
likely the sear isnt catching the bolt because its low on power or the trigger assembly parts are rough or dirty ... first just swab the barrel out good, clean it .. that may do it .. if you have some spray silicone id goose alittle up into trigger assembly and around the hammer ...
Upvote 0
Thank you, dizzums. You are exactly correct! A little silicone oil on the parts and it hasn't done it since! Thanks again!!
Upvote 0
